Read all about the latest OP Prison developments; Master Prestige Levels, Token Outpost, Private Mines, & MORE!
Discussion in 'Feedback And Suggestions' started by AussieHunter, May 10, 2019.
fix printing in stuff its slow and glitchy, and add /printer to make it easier to print
Is it your printer / schematic that your using?
If you use schem there is a way to build fast
Suggest you watching videos on configs to print faster.
Its better to just config schematica so it works well with the server. As said above, watching a video on making schematica printer faster would be your best bet.
Build it by hand xd be more original
Wrong... there is no config that ensures everything gets printed. Do /fps refresh after each time you print to ensure that everything gets printed properly.
You can't accurately check if all the blocks are being placed because you will definitely miss out a few. Not sure if there is a fix to this. But i feel it's not much of an issue as there are ways to check. Perhaps lower the cooldown on /fps refresh.
He may build in a different server, Then use schem
A tip: Use quickdraw I-II on an item and print with that in your hand.
It will make placing a bit faster.